Copper alloy strip for consumer electronics and appliances
We supply strip to the stamping plants and connector makers behind phones, laptops, wearables, chargers and home appliances. The tables below give the grades usually specified for each kind of part.
Connector terminals and contacts
Phosphor bronze is the everyday choice for board, I/O and wire-to-board terminals. Copper-nickel-silicon grades take over where the pitch is fine or the contact must carry more current in the same space.
| Grade | UNS | Conductivity %IACS | Tensile strength MPa | Alloy |
|---|---|---|---|---|
| C5191 | C51900 | 13 – 15 | 315 – 685 | C5191 Phosphor Bronze Strip |
| C5210 | C52100 | ≈ 12 | 470 – 885 | C5210 Phosphor Bronze Strip |
| C5240 | C52400 | ≈ 11 | 650 – 1000 | C5240 Phosphor Bronze Strip |
| C7025 | C70250 | ≥ 40 | 620 – 860 | C7025 Copper-Nickel-Silicon Strip |
| C7035 | C70350 | ≈ 50 | 770 – 970 | C7035 Copper-Nickel-Cobalt-Silicon Strip |
Miniature springs and battery contacts
The smallest springs need the highest strength so that a thin section still gives the contact force.
Shielding cans, shells and general stampings
Charger and appliance power contacts
Plug pins, power contacts and heat spreaders that carry mains or charging current.
How we supply stamping plants
- Strip slit to each width on your list, in the thickness and temper your tooling was set up for. Thickness by alloy: beryllium copper, copper-titanium and other high-performance alloys 0.03 mm to 0.25 mm; phosphor bronze and other alloys 0.08 mm to 1.8 mm; pure copper 0.10 mm to 6.0 mm.
- Quoted to the UNS, EN or JIS designation on your drawing; we confirm the equivalent before quoting.
- Every coil carries its lot number and ships with the test certificate, so incoming inspection has what it needs.
- Repeat orders against a forecast or a blanket order, shipped by sea or air. See export supply and supply to Europe.
- Samples and small qualification lots with the same documents as production shipments.
What to send for a quotation
Grade and temper, thickness and width with tolerances, monthly or annual quantity, and the destination port. If the grade is still open, send the part drawing and the current it carries and we will propose grades with the trade-offs.
Related guides
Request a quotation
Send us the grade, temper, thickness, width and quantity. We reply within one working day.
Send RFQ