Copper alloy selection for fine-pitch connector terminals
For board-to-board, FPC and USB Type-C terminals stamped from strip of 0.06 to 0.15 mm, start with C7025. Move to C7035 when the pitch or thickness shrinks and force must be kept. Use C5240 for low-current springs where cost matters, and copper-titanium where the highest strength is needed without beryllium.
Candidate grades
| C7025 | C7035 | C5240 | C1990 | YCuT-FX | |
|---|---|---|---|---|---|
| UNS | C70250 | C70350 | C52400 | C19900 | C19900 |
| Equivalents | EN CuNi3SiMg; JIS C7025 | EN CuNi1Co1Si; JIS C7035 | JIS C5240 | JIS C1990; EN CuTi3 | JIS C1990 |
| Composition % | Ni 2.2 – 4.2, Si 0.25 – 1.2, Mg 0.05 – 0.30 | Ni 1.0 – 2.5, Co 1.0 – 2.0, Si 0.5 – 1.2 | Sn 9.0 – 11.0, P 0.03 – 0.35, Cu + Sn + P ≥ 99.7 | Ti 2.9 – 3.5 | Ti 3.2 |
| Conductivity %IACS | ≥ 40 | ≈ 50 | ≈ 11 | 8 – 13 | 13 |
| Tensile strength MPa | 620 – 860 | 770 – 970 | 650 – 1000 | 885 – 1180 | 985 – 1115 |
| Tempers | TM00, TM02, TM03 | TM04, TM06 | H, EH, SH, ESH, XSH | EH, SH, ESH | H, EH, SH, ESH |
| Elastic modulus | 131 GPa | 131 GPa | 105 GPa | 127 GPa | 125 GPa |
| Density | 8.82 g/cm³ | 8.82 g/cm³ | 8.78 g/cm³ | 8.70 g/cm³ | 8.7 g/cm³ |
Tensile strength is the range across supplied tempers. Full composition, tempers and physical properties are on each grade page.
What the material has to do
- Hold normal force in a very thin, short beam: high yield strength
- Survive tight bends without cracking: bend formability in the chosen temper
- Keep that force over the product life: resistance to stress relaxation
- Carry the rated current without overheating: conductivity
Notes
Charging and power pins in the same connector often need a more conductive alloy than the signal pins. Tell us the current per pin and we will propose a grade for each.
Questions buyers ask
Which temper should a fine-pitch terminal use?
The hardest temper that still passes your tightest bend. Send the bend radius and direction relative to rolling, and we will suggest the temper.
Need a recommendation for a specific part?
Tell us the part function, strip thickness and performance targets. We reply within one working day, and sample coils are available for comparative trials.
Material development support