C18140 vs C19400: high-conductivity alloys for power terminals and lead frames
C19400 is the economical standard for lead frames and general power terminals at 60 % IACS or more. Choose C18140 when the part carries more current or runs hotter: it conducts about 85 % IACS and, as a precipitation-hardened chromium-zirconium copper, resists softening better.
Side-by-side data
| C18140 | C19400 | |
|---|---|---|
| UNS | C18140 | C19400 |
| Equivalents | EN CuCrZr (low-alloyed) | EN CuFe2P / CW107C; JIS C1940; GB QFe2.5 (TFe2.5) |
| Composition % | Cr 0.15 – 0.45, Zr 0.05 – 0.25, Si 0.005 – 0.05 | Fe 2.1 – 2.6, P 0.015 – 0.15, Zn 0.05 – 0.20, Cu ≥ 97.0 |
| Conductivity %IACS | 85 | ≥ 60 |
| Tensile strength MPa | 393 – 490 | 365 – 550 |
| Tempers | H04, H08 | 1/2H (H02), H (H04), EH (H06), SH (H08), ESH (H10) |
| Elastic modulus | 117 GPa | 121 GPa |
| Density | 8.91 g/cm³ | 8.91 g/cm³ |
Tensile strength is the range across supplied tempers. Full composition, tempers and physical properties are on each grade page.
Choose C19400 when
- The part is a standard lead frame or terminal and cost matters
- 60 % IACS meets the temperature-rise target
- Wide availability and many tempers are useful
Choose C18140 when
- Current density is high: battery, charging and power-distribution terminals
- The part sees soldering, welding or sustained heat and must not soften
- The alternative would be pure copper, which is too soft for the design
Notes
Both are far more conductive than connector spring alloys. Neither is a spring material for small contacts; where a spring feature is needed on a power terminal, a copper-nickel-tin or Corson alloy is usually used for that part.
Questions buyers ask
How much cooler does a C18140 terminal run than a C19400 one?
Bulk resistance is roughly 30 % lower for the same cross-section. The actual temperature difference depends on the joint and the surroundings and should be measured.
Need a recommendation for a specific part?
Tell us the part function, strip thickness and performance targets. We reply within one working day, and sample coils are available for comparative trials.
Material development support